Supco Digital pressure gauge 0-1000 PSI

DPG Instructions Relative Operation DPG1000 The Zero button allows the user to set the DPG to 0 for relative Product Specifications measurements. This can be done at any pressure reading and in The DPG is a media compatible digital pressure gauge featuring any measurement units. The LCD display will indicate “R” in the multiple units, selectable zero reference and automatic power off to Pressure Range -14 to +1000 PSI upper left hand corner of the display to show that the gauge is conserve battery power. The DPG is compatible with any liquid or Measurement Units PSI, BAR, Kg/cm2, ATM operating in the relative mode. Depressing the Zero button while in gas that is compatible with 17-4 PH stainless steel. The pressure Accuracy < ± 0.5% BFSL(includes the Relative mode will return the DPG to zero referenced gauge sensor is a one-piece high strength stainless steel design and Non-linearity, Hysteresis operation. and Non-repeatability) contains no silicone oil, no welds and no internal O-rings. All functions of the DPG are controlled from the three pushbuttons Stability (1 year) ±0.25%FS (typ) Set Zero Overange Protection 2X Rated Pressure on the front of the gauge. Over the course of time and under normal use it may become Burst Pressure 5X or 20,000 psi necessary to set the zero of the gauge. To set the zero of the gauge which ever is less. Power turn the gauge off by pressing the power button. Then press and Pressure Cycles >100 Million Press and release the power button to turn the DPG On and Off. Operating Temperature Range 32°F to 130°F hold the Power button and the Zero button for 5 seconds. The LCD If the display is blank or unreadable make sure the gauge has a (0°C to 55°C) display will show “Set Zero” and after a short period return to fresh battery and adjust the contrast control as needed. Storage Temperature Range -40°F to 150°F gauge operation. If no button is pushed for approximately one hour the DPG will (-40°C to 65°C) Note that this MUST be done at zero pressure. Any attempt to reset automatically turn off to conserve battery power. Compensated Temperature Range 32°F to 130°F zero at a positive or negative pressure will display “Out of Range” ( 0°C to 55°C) and the zero set function will be canceled. Temperature Compensation Zero <±1.5% of FS Measurement Units The measurement units of the DPG can be selected by pressing Temperature Compensation Span <±1.5% of FS Battery Replacement Pressure Sensor Connection 1/8th NPT Female and releasing the Units button. Locate the battery compartment door on the back of the Update Rate 3 Samples per second(typ) The available measurement units are PSI, Bar, Kg/cm2, and ATM. instrument. Power 9-Volt Alkaline Battery Each press of the Units button will cycle to the next unit of Slide the door to the right to access the battery compartment. Automatic Power Off 1 Hour measurement. Battery Life 100 Hours Continuous Carefully remove the old battery from the battery clip and replace it The selected units of measurement will not change when the DPG operation (typ) with a fresh 9 Volt Alkaline battery. Place the battery in the battery is turned off or when the battery is changed. Instrument Case High Impact ABS compartment and close the battery compartment door by sliding it to the left until it clicks into place. 1 2 3